MK PRODUCTS - 07/01/02

COBRATIG UPDATE FILES - VERSION XM03A1

This CobraTig Firmware, Version XM03A1 has Extended Memory capability. Version XM03A1 can only be used in CobraTig Model 254-151.

To properly perform this firmware upgrade, a Null Modem Interface Cable must be connected between the CobraTig and the PC/Laptop serial port. Follow the cable connection and CobraTig setup instruction in this kit. This can be purchased from MK Products: P/N 005-0323.

Instructions:

For easiest navigation, unzip file and save the "XM03A1.bin" and "MKEdit-V2.exe" files into the same directory.

Double-Click and run the "MKEdit-V2.exe" application to start the SmartArc Weld Program Editor. To send the firmware upgrade into the CobraTig, select 'Send' and choose 'Send Firmware Upgrade to CobraTig'.

When locating the "XM03A1.bin" file for upgrading, change the Files of Type: to 'All files (*.*)'. Choose the "XM03A1.bin" file and click on 'OPEN'.

Continue with Firmware upgrade as instructed on screen on PC/Laptop.

WARNING:

Disconnect Null Modem cable prior to welding. Failure to disconnect cable can and will result in damage to the electronics of the PC/Laptop.

WARNING: 

Installing new Firmware will erase any saved weld procedures from the CobraTig. Use the Communication Menu to save weld procedures onto PC/Laptop.

The files listed in the above text are only available via a written request by email.  This request MUST included CobraTig serial number & current Firmware Version number.

For assistance, contact MK Technical Support: 949-863-1234.